![]() or the inverse - put your DSL modem into a bridge mode to use the features of your router. Email me if you wish, but I think you've got enough info here to go on. A "stealth" firewall mode would be welcome too, to be completely invisible on the net.So, I think your best bet is to get a separate router/firewall and put the Extreme in BRIDGE mode. We'd like a way to enable access to AirPort Disk from only selected IP address ranges. The AirPort Utility has no way to configure or adjust this firewall. The only "open" ports nmap detected were ports we had specifically forwarded to a computer behind the network. A more sophisticated scan with the nmap tool shows it to be online but filtering. In a quick network scan of the sort used to find targets for attack, the base station appears to be "down" (offline). The firewall, though basic, is functional. I found this on the Web re: the Extreme's firewall:Īpple advertises AirPort Extreme's built-in firewall as a key security feature. It's really just a matter of opening port 8000, or whatever port you tell Nicecast to use. ![]() There are some very inexpensive router/firewall options that will do what you need, and it's a good idea to have a firewall between your extreme and cable modem anyway!! ![]() This may be your easiest solution anyway. As has already been mentioned, my Extremes are setup in BRIDGE mode since the router/firewall handles all IP addresses. I've got Extremes as well, but am using a very expensive Router/Firewall for the complex, which is where the ports need to be opened. I'm using a new Airpot Extreme base station. I picked up Nicecast.can you share your network / router settings and Nicecast settings.I can DM you if that's better. I tried to port map last night until my breaking point.I followed all the instructions that I could come across regarding port mapping with my Apple Airport.still all failed.I'm obviously doing something incorrect.maybe it's how the modem is setup (I use Verizon DSL here in NYC) When determining if your router can do this, see if it's an approved device for the gaming crowd. PPS - incoming part mapping is a common feature for gamers. PS - you'll have the same port mapping "issue" with any of the possible solutions. Then I simply followed the nicecast instructions - and all was perfect. Took a call to level 3 support at Time Warner Cable to learn that you can't always "simply" slap a router on some cable modems if you want incoming port mapping. Discovering that was the solution for me. ![]() Router mapping is crucial - and depending on your broadband connection, your "modem" may need to be provisioned as a bridge. Nicecast works for me! I documented it here: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |